
Seat covers do two jobs. They protect the seats the car came with from wear, spills, mud and hair, and they can make tired or stained seats look and feel new again. Getting them right is mostly about four things: how many seats you need to cover, what material suits the way you use the car, whether your seats have airbags in their sides, and how well the covers are fitted. This guide goes through each in turn, then covers rear benches that split and fold, and the driver's seat and double passenger seat of a van.
Why fit seat covers
The seats take more wear than any other part of the inside of a car. Every time you get in, you slide across the outer edge of the seat base and the side bolster, and over years that wears through fabric and creases leather. Add work clothes, wet coats, muddy boots, children with drinks and snacks, and dogs, and the seats are often the first part of an interior to look tired.
Covers protect against all of that. They are much easier to clean than the seats, and many can be taken off and washed. If you lease a car or plan to sell it, keeping the original seats clean helps when the car is inspected or valued. If the seats are already worn, faded or stained, covers are a far cheaper way of tidying them up than having them retrimmed.
They can also change how the seat feels. A soft fabric cover can make a hard seat more comfortable, a breathable one can make a hot seat bearable in summer, and a leather-look cover can give a plain interior a smarter look. For more comfort than a cover can give, seat cushions sit on top of the seat base and work with or without covers.
Full sets or front pairs
Seat covers are usually sold either as a full set for the whole car or as a pair for the two front seats.
Full sets
A full set normally covers the two front seats and the rear bench, with separate pieces for the seat bases, the backrests and the headrests. It is the choice when you want the whole interior to match, when the rear seats get as much use as the front, or when you are covering up worn or stained seats throughout the car. Look at the full sets of car seat covers if that is you.
Front pairs
A front pair covers only the driver's and front passenger seats. The front seats take most of the wear in many cars, especially for someone who drives alone or with one passenger, so a pair is often all that is needed. A pair is also useful when the back seats need a different kind of cover: a smart leather-look pair in the front, for example, with a tough waterproof cover or a dog cover on the rear bench. The front car seat covers range has pairs in different materials.
Universal and fitted
Most covers are universal, made to stretch over the common shapes of car seat. They fit most cars well, but not every seat. Large side bolsters on sporty seats, seats with built-in headrests, and unusual rear benches can all be harder to cover neatly. Before you choose, look at your seats and note the things that matter: whether the headrests come out, whether the front seats have side airbags, whether there is a fold-down armrest, and how the rear bench splits. The product description will tell you which of these a cover allows for.
Fabric, PU leather and neoprene
The three materials you will see most each suit a different kind of use.
Fabric
Fabric covers, usually polyester or a blend, are soft, breathable and comfortable in hot and cold weather alike. They come in the widest range of colours and patterns, and many can be washed. Their weakness is that liquids soak in, so they are less suited to a car that carries muddy kit or dogs. Mesh and quilted fabrics add some padding and let air move under you, which helps on a long drive in summer.
PU leather
PU leather is a man-made leather finish. It gives the look of a leather interior, it wipes clean, and spills sit on the surface long enough to be mopped up, which makes it popular with families. Like real leather, it gets warm in strong sun and cold on a winter morning, and perforated or quilted panels help with both. Over time any leather finish can crease where you get in and out most. The leather car seat covers range covers leather and leather-look finishes.
Neoprene
Neoprene is the stretchy, rubbery material wetsuits are made from. It resists water, it is soft to sit on, and because it stretches it fits snugly over most seat shapes. It is a favourite for people who get into the car wet or sandy after surfing, swimming, cycling or a day outdoors. It is less breathable than fabric, so it can feel warm in summer.
| Material | Good for | Think about |
|---|---|---|
| Fabric | Everyday comfort, breathability, colour choice | Liquids soak in |
| PU leather | A smart look, wiping clean, families | Warm in sun, cold in winter |
| Neoprene | Water, sand, sport, a snug fit | Less breathable |
Waterproof covers for work, sport and the school run
If the seats regularly meet water, mud, sweat, dust or spilt drinks, a waterproof cover is the one that will actually keep them clean. That covers a lot of drivers: builders and gardeners in work clothes, walkers and anglers, people coming back from the gym or the beach, and parents doing the school run with football kit and juice cartons.
What makes a cover waterproof
A waterproof cover has a coated fabric, a waterproof backing layer, or is made of a material like neoprene or PU that does not let water through. The seams matter as much as the material: water finds its way through stitching, so a cover that is waterproof across its panels but has open seams across the seat base will still let a wet patch through. A non-slip backing helps too, because a waterproof cover is often slippery on its top surface and can slide around if the back does not grip.
Covers you can take off in seconds
Some waterproof covers are made to be left on all the time. Others are simpler throw-over covers that you put on for a muddy day and take off afterwards, held by a headrest strap and an anchor pushed into the seat gap. The second kind is useful when the car is mostly clean but sometimes has to carry wet people or kit. The waterproof car seat covers range has both.
Children and dogs
Child seats can press marks into the seat beneath them, and crumbs and spills collect underneath. A seat protector made for child seats sits under the child seat and is designed for the job. Whatever goes under a child seat, follow the child seat maker's instructions on what may be placed beneath it, and make sure the seat belt or the ISOFIX fittings can still be used exactly as the child seat's instructions describe. For dogs, a dedicated dog seat cover or hammock is tougher and covers more of the seat and footwell than an ordinary cover. There is a separate guide to travelling with a dog in the car.
Side airbags: what to check first
This is the most important section of the guide. Many cars have side airbags built into the outer side of the front seat backrests. When one goes off, it bursts out through a seam in the seat's own upholstery, in a fraction of a second, to protect the person in the seat from a side impact. A seat cover that is stitched solidly across that seam can hold the airbag back or change the way it opens.
How to tell if your seats have side airbags
Your car's handbook shows where every airbag is, and it is the place to be certain. Some seats also have a small tag or label on the outer side of the backrest marking the airbag, but not all do, and the tag can be lost or hidden, so do not rely on it alone. The handbook may also say whether seat covers can be used on those seats and what kind. If it says not to fit covers, do not fit them.
Covers made to be airbag compatible
If your seats have side airbags, only use covers that are made to be airbag compatible. These have a special seam or an opening on the side where the airbag comes out, designed to give way and let the airbag through. The product description should say plainly that the cover is airbag compatible. If it does not, assume it is not.
Fitting matters as much as the cover. The compatible seam or opening has to sit on the side of the seat where the airbag is, which on the front seats is usually the side nearest the door. Each cover is often marked for the left or the right seat, and a cover fitted the wrong way round puts the special seam on the wrong side. When the covers are on, check both front seats against the handbook to make sure the seam is where the airbag is.
Other things on the side of the seat
The same thinking applies to anything else that goes on a seat with a side airbag. Heated seat covers, massage cushions and anything that straps around the backrest should leave the airbag side clear. Do not hang bags or coats over the outer side of a front seat with an airbag in it.
Rear benches: one piece or split
The rear seat is where universal covers are most likely to go wrong, because rear benches vary so much from car to car.
Split folding seats
Most cars have a rear backrest that splits and folds, very often in two unequal parts, so you can fold one side for a long load and still carry a passenger on the other. Some split into three. A one-piece cover across a split backrest stops you folding one part on its own, and has to be undone every time you want to use the boot to its full size. A split cover has separate pieces, or zips, that match the split. Count how your backrest divides and look for a cover that matches it. If you never fold the seats, a one-piece cover is simpler and stays put well.
Armrests, belts and headrests
Many rear backrests also have a fold-down centre armrest, sometimes with a hatch behind it for long items. A cover needs a zipped opening there, or the armrest will be buried. The seat belt buckles that come up between the base and the backrest need to stay reachable, so check that the cover has openings for them, and that every buckle can still be found and fastened without lifting the cover. The rear headrests may have their own covers, or the backrest cover may go around them.
Child seat fittings
If you use ISOFIX child seats, the fittings sit in the gap between the rear seat base and the backrest. The cover must leave them clear and reachable so the child seat can lock onto them exactly as its instructions say. A full set with openings for ISOFIX is the answer, or leave that part of the bench uncovered and use a child seat protector instead.
Fitting covers so they stay put
Most complaints about seat covers come down to fitting. A cover that is loose wrinkles, slides around and wears quickly. A cover that is fitted carefully looks far better and lasts longer. Allow time for it, especially the first time.
The usual order
- Clean and vacuum the seats first, because anything left underneath stays there.
- Take the headrests out. On most cars there is a small button at the base of one of the headrest posts to press while you lift.
- Slide the backrest cover down over the backrest from the top, working it evenly down both sides. On a seat with a side airbag, check you have the cover for that side and that the special seam is on the airbag side.
- Push the flaps or straps at the bottom of the backrest cover through the gap between the backrest and the base, and pull them through from behind.
- Fit the base cover, pushing its rear edge into the same gap, and take its straps and hooks under the seat.
- Join the straps under the seat and pull them snug. Hook them onto the seat's own frame or springs, never onto wiring, the seat's runners or the parts that move when the seat slides or tilts.
- Put the headrest covers on and refit the headrests through the holes in the cover.
- Check that the seat belt, its buckle, the seat adjusters and any controls on the side of the seat all still work, and that nothing gets in the way of you sitting properly.
After the first week
Covers settle as they are sat on. After a week or so of driving, pull the straps tight again and smooth out any creases. Small things help a cover stay put: the anchors many covers have, tubes or discs pushed down into the seat gap, stop the cover creeping forward, and seat gap fillers on the front seats keep the edges tucked in and stop phones and keys falling down the side.
Heated and electric seats
If your seats are heated, a cover will slow how quickly you feel the warmth, more so with a thick or padded one. With electric seats, take extra care under the seat, where there are motors and wiring, and keep every strap clear of them.
Van seat covers and double passenger seats
Most vans have a single driver's seat and a double passenger seat for two people. Van seats take harder wear than most car seats, from work clothes, tools, dust and constant getting in and out, so van covers are often made of heavier fabric or waterproof material.
The double passenger seat
The double seat is the one to check carefully. In many vans the middle backrest folds down to become a table or a storage tray, and some have a storage compartment under the seat base. A cover needs to match. If you use the fold-down table, the cover needs a separate piece for that backrest, or an opening for it, otherwise the table is hidden. If there is storage under the base, the cover needs to allow the base to lift.
Armrests, belts and airbags
Driver's seats in vans often have one or two armrests that need slots in the cover. Some van seats have the seat belt built into the seat itself, and the cover must leave it running freely. Vans can have side airbags in the seats too, and everything in the section on side airbags applies to a van exactly as it does to a car: check the handbook, and only fit covers made to be airbag compatible on seats with side airbags.
The van seat covers range is the place to start, and the van accessories range covers the rest of the cab. A tidy cab with van cab organisers and van floor mats keeps tools and dirt off the seats in the first place.
Questions
Can I fit seat covers to seats with side airbags?
Only covers that are made to be airbag compatible, fitted with their special seam on the side where the airbag is, and only if the car's handbook allows covers on those seats. If you are unsure whether your seats have side airbags, the handbook will show you.
Will universal covers fit my car?
They fit most cars, because they stretch over the common seat shapes. Check the things that vary: removable headrests, side airbags, a fold-down armrest, and how the rear backrest splits. If your seats have very large side bolsters or built-in headrests, read the description carefully.
Can a child seat go on top of a seat cover?
Follow the child seat maker's instructions on what may go underneath it. Whatever you use, the child seat must be fitted exactly as its instructions describe, with the seat belt or ISOFIX fittings fully usable.
Which cover is best for a car that gets muddy?
A waterproof cover with sealed seams and a non-slip backing, or neoprene. For a dog, a dog seat cover or hammock covers more of the seat and the footwell.
How do I clean seat covers?
Fabric and neoprene covers can often be taken off and washed, and PU leather is wiped clean with a damp cloth. Always follow the washing instructions for the cover you have, and let it dry fully before refitting.
Where to go next
Browse all car seat covers, or go straight to the full sets, front pairs, leather or waterproof covers above. For a cleaner car all round, an interior cleaning kit handles the rest. Delivery is included in every price and tracked to your door. Other guides that help:
- Travelling with a dog in the car: dog covers, hammocks and boot liners
- Choosing car floor mats: protecting the footwells as well as the seats
- Choosing a car air freshener: dealing with smells in the fabric
- Choosing a car phone holder: setting up the rest of the driver's area


