
A load that moves is a danger to the people in the vehicle, to other road users and to the load itself. A box of tiles that slides forward in a van, a flat-pack wardrobe that shifts against the back seat of a car, or a ladder that works loose on a roof rack can all cause harm in a moment. This guide starts with what the law expects of a load, then goes through ratchet straps, cam buckles and lighter tie-downs, cargo nets, hooks and anchor points, keeping small things from sliding, and checking the load once you are on the way.
What the law expects of a load
The rules on loads apply to every vehicle, not only to lorries. A car with a boot full of garden waste and a van on its way to a job are covered in the same way.
The law itself
The Road Vehicles (Construction and Use) Regulations 1986 set out the duty in regulation 100. In plain words, the load must at all times be secured, if necessary by physical restraint other than its own weight, and be in such a position that it is not likely to cause danger or nuisance to anyone by falling or being blown off the vehicle, or by moving about on it. The same regulation says the weight, distribution, packing and adjustment of the load must be such that no danger is caused, or likely to be caused, to anyone in the vehicle or on the road.
The Highway Code
Rule 98 of the Highway Code puts it more shortly. You must not overload your vehicle or trailer, you must secure your load, and it must not stick out dangerously. The same rule asks drivers to make sure any heavy or sharp objects, and any animals, are secured safely. The Highway Code's Annex 6 adds that luggage should be securely stowed.
The government's guidance on securing loads
The Driver and Vehicle Standards Agency publishes detailed guidance on securing loads. Most of it is written for lorries and goods vehicles, but it includes a section on vans and cars, and its basic principles apply to any load:
- The way a load is secured should hold the entire weight of the load against moving forwards, and half the weight against moving to the sides or backwards.
- You cannot rely on the weight of a load alone to keep it in place once the vehicle is moving.
- A cover or sheet over a load does not hold it in place by itself.
- The load should not block the driver's view, including the view in the mirrors.
- Heavier items go at the bottom, and the load should be kept low and towards the centre.
For cars it adds that a load should be secured so there is no risk of harm to the driver, passengers or other road users, whether it is carried for work or for leisure.
Overloading
Every vehicle has a maximum weight it can carry, and the handbook gives it. A load that is properly strapped but too heavy still affects braking, steering and the tyres, so check the weight of what you are carrying, not only how it is held.
The penalties
GOV.UK's list of endorsement codes includes CU50, causing or likely to cause danger by reason of load or passengers, which carries three penalty points. The DVSA's guidance adds that using a vehicle in a dangerous condition can lead to an unlimited fine, a driving ban and penalty points, and that a load which causes a collision can lead to charges of careless or dangerous driving.
Ratchet straps and how to use them
A ratchet strap is a length of flat woven webbing with a hook at each end and a ratchet in the middle. Working the ratchet handle pulls the webbing tight and locks it. It is the most common way of holding a load in a van or on a roof rack, and the DVSA guidance names cargo ratchet straps as one of the right ways to hold a load on a roof rack.
Reading the label
A strap made to the standard for web lashings, BS EN 12195-2, carries a label. The DVSA guidance says the two figures that matter are the lashing capacity, marked LC, and the standard tension force, marked STF, both given in daN. The lashing capacity is how much force the strap can take in a straight pull. The standard tension force is how tight the ratchet pulls it in normal use. The label also shows the date it was made. A strap with no label, or a label you cannot read, is a strap you know nothing about. The guidance also suggests keeping a note of each strap's rating, in case the label is torn off later.
Two ways of using a strap
- Over the top. The strap goes over the load from one side of the floor to the other and is tightened, pressing the load down so it grips the floor. The DVSA calls this frictional lashing. It works best with the strap as close to upright as possible, because a strap at a shallow angle presses down very little.
- Direct. The strap runs from the load itself to an anchor point on the vehicle, holding it in one direction. Two straps pulling in opposite directions hold the load between them.
Step by step
- Place the load against the bulkhead in a van, or against the back of the rear seats in a car, with heavy items low.
- Hook each end to a proper anchor point, never to anything not made to take the strain.
- Lay the webbing flat, with no twists, and put a sleeve or a piece of protection over any sharp or rough edge on the load.
- Pull the slack through by hand, then work the ratchet until the strap is tight and the load does not move when you push it.
- Close the ratchet handle so it locks, and tuck away the loose tail so it cannot flap or catch.
Looking after straps
The DVSA guidance says straps should be checked before each use and replaced if they are badly damaged. Look for cuts, fraying, burns, stiff or rusty ratchets and bent hooks. Never tie a knot in a strap that is under tension, because a knot weakens it badly. Keep straps dry, out of oil and dirt, and in a box or bag rather than loose in the van. When you undo a strap at the end of the journey, stand clear and check the load has not shifted against it first, because a load that has moved can fall when the strap is released. The ratchet straps and tie-downs range shows the different lengths and widths.
Cam buckles and lighter tie-downs
Not every load needs a ratchet. For lighter things, a strap with a cam buckle is quicker to use and less likely to crush the load.
Cam buckle straps
A cam buckle strap has a spring-loaded buckle with teeth. You pull the free end of the webbing through by hand and the buckle grips it. There is no handle to wind, so it cannot be pulled as tight as a ratchet strap. That makes it a good choice for loads that a ratchet could damage, such as boxes, bikes on a carrier, a canoe on roof bars or a bundle of light timber, and for holding things inside a car boot. For heavy loads, a ratchet strap is the stronger choice.
Bungee cords
Bungee cords stretch, which is exactly what you do not want in a restraint, because the load can move as far as the cord stretches. The DVSA's guidance on cars says rope, bungee cords, cords and cables are not effective for holding a load on a roof rack, and that rope is not suitable for securing a load for a journey. Bungees have a place holding a cover down over a load that is already secured, or keeping light shopping in a corner of the boot, but not as the thing holding a load in place.
Roof racks
The DVSA guidance says never to load directly onto a car roof, because it is not designed for it and there is nothing to hold onto. Use roof bars or a rack, keep within the maximum roof load in the handbook, and secure the load with ratchet straps or proper clamps. Long items that stick out past the front of the rack should also be tied to the front of the vehicle to stop them swinging from side to side.
Cargo nets for a boot or load area
A cargo net is a stretchy or fixed net with hooks or loops at its corners and edges. It is a good way of holding a mixed load of lighter items, such as shopping, sports kit or bags, against the floor or the side of the boot.
What a net can and cannot do
The DVSA guidance makes a point worth knowing: nets and sheets contain a load but do not secure it. A net stops things bouncing about and spilling, but it is not a substitute for straps on anything heavy. Nets also have gaps, so small items can slip through. Used with a strap or two on the heavy pieces, a net over the top keeps everything else in place.
The kinds of net
- Floor nets stretch flat across the boot floor and hook to the car's tie-down points, holding bags and boxes against the floor.
- Envelope nets hang upright across the back or side of the boot, making a pocket for smaller things such as a bottle of screenwash or a first aid kit.
- Larger load nets go over a pile of items in a van or on a trailer and hook to the anchor points around it.
Choosing one
Measure the space between the boot's tie-down points, or the van's anchor points, before you choose, and pick a net with a mesh small enough for the things you carry. A net that is too big will sag and hold nothing, and one that is too small will be stretched so tight it is hard to fit. The cargo nets range shows the sizes.
Hooks and anchor points
A strap or net can only be as strong as what it is hooked to. The DVSA guidance puts it plainly: any lashing is only as strong as its weakest part, and that includes the point it is fixed to.
In a van
Most vans have lashing points built into the floor or the lower sides of the load area. These are made to take the strain of a strap. Use them for anything heavy. The DVSA guidance adds some rules for anchor points: check they are in good condition, with no damage or distortion, do not attach more than one strap to a single anchor point, and do not thread a strap through an anchor point and hook it back onto itself. It also says that hooks for sheets or ropes must not be used as anchors for straps.
In a car
Many car boots have small tie-down eyes in the floor or the sides. These are for nets and light straps, and the handbook will say what they are meant for. Bag hooks on the side of the boot are for shopping bags only. Never hook a strap to a parcel shelf support, a seat frame or a plastic trim panel.
Extra hooks
Load area hooks add places to hang light things in a van, such as cables, bags and hi-vis vests, so they are not lying on the floor. They are for light items. For anything that needs holding down, use the van's own lashing points.
Keeping small things from sliding
A load does not have to be big to cause trouble. A loose toolbox, a can of paint or a bag of shopping can slide, tip and spill, and anything heavy can be thrown forward under hard braking.
Load against something solid
The DVSA's advice for vans is to load items against the bulkhead where possible, group smaller items together in a box or container, and secure large or heavy items to the vehicle. For cars it says to load the boot against the back of the seats and to fill the gaps so the load cannot slide. A gap is what lets a load build up speed before it stops, so the fewer gaps the better.
Boxes, crates and organisers
Small things are easiest to control in a container. A boot organiser with dividers keeps shopping, cleaning kit and emergency kit upright and in one place, and many have non-slip bases or straps. In a van, tool bags and tool rolls keep hand tools together instead of rolling around the floor. A box or crate that is itself strapped down holds everything inside it.
Grip on the floor
A smooth floor lets things slide. A boot or cargo liner with a textured surface gives more grip, and it protects the floor from scrapes and spills at the same time. In a van, van floor mats do the same for the cab.
Heavy at the bottom
Put the heaviest things at the bottom and nearest the front of the load area, with lighter things on top. A heavy box on top of light ones crushes them and is more likely to topple. In a car, keep the back seats upright and locked in place when there is a load behind them, so the seat backs act as a barrier. If a dog travels in the boot with other things, see the guide to travelling with a dog in the car: rule 98 asks for animals to be secured too, and loose items in the boot can slide into a dog.
Checking the load on the way
A load that is secure when you set off may not stay that way. Straps settle and loosen, loads shift as they bed down, and some weather needs extra care.
Before you set off
Push the load and check it does not move. Check every strap is tight and its ratchet locked, every hook is on its anchor point, and nothing blocks your view in the mirrors. The DVSA guidance says that if you have any doubt about a load, do not set off.
On the way
Stop after the first few miles, somewhere safe, and check again. Straps often need a little more tension once the load has settled. The DVSA guidance says drivers should check restraints during the journey, and on a run with several drops, that the load is still safe after each one, because taking part of a load off can leave the rest loose. Wet weather, snow, ice and strong winds may call for extra straps. A torch makes checking a load at night much easier, and van interior lights help when you load in the dark.
If the load moves
If you feel or hear the load shift, slow down gently and avoid sudden braking or steering. Find a safe place to stop, then re-secure it. The DVSA guidance says you must not carry on until the load is secure.
If something falls off
Rule 280 of the Highway Code says that if anything falls from a vehicle onto a motorway or other high-speed road, do not try to remove it yourself: stop somewhere safe and call 999. On other roads, remove it only if it is safe to do so. Wearing a hi-vis vest helps others see you if you do have to stop at the roadside, and warning triangles and hi-vis vests are worth carrying, although the Highway Code says a warning triangle must never be used on a motorway.
Questions
Is it illegal to drive with an unsecured load?
Yes. The law requires a load to be secured so that it is not likely to cause danger or nuisance, and the Highway Code says you must secure your load. Causing danger by reason of a load carries three penalty points.
How tight should a ratchet strap be?
Tight enough that the load does not move when you push it, and no tighter than the load can stand. Lock the ratchet handle closed once it is tight.
Can I use bungee cords to hold a load?
Not as the main restraint. The DVSA says bungee cords and rope are not effective for holding a load on a roof rack. Use ratchet or cam buckle straps, and keep bungees for holding a cover over a load that is already secured.
Does a cargo net secure a load?
A net contains a load but does not secure it. It suits light items. Anything heavy needs straps to proper anchor points.
Where should heavy things go in a car?
In the boot, low down and against the back of the seats, with the gaps filled so nothing can slide, rather than on the back seat or the parcel shelf.
How often should I check the load?
Before you set off, after the first few miles, at every stop or drop, and whenever you feel it move.
Where to go next
The straps, nets and hooks in this guide are in the ranges ratchet straps and tie-downs, cargo nets and load area hooks, and more for working vans is for tradespeople. Delivery is included in every price and tracked to your door. Other guides that help:
- Organising a van cab: keeping the cab clear while the load stays in the back
- Choosing car floor mats: boot liners and rubber mats that give a load some grip
- How to organise your car: boot organisers and storage for everyday things
- What to keep in your car for emergencies: the kit for a roadside stop


